Emulsification Pump Is Superior In Quality
The Emulsification Pump sealed oil chamber is equipped with a high-precision anti-interference water leakage detection sensor, and the stator winding is pre-buried with a thermal element, which absolutely protects the water pump motor. The unique single-blade or double-blade impeller structure greatly improves the ability to pass dirt, and can effectively pass fiber materials 5 times the pump diameter and solid particles with a diameter of about 50% of the pump diameter.
The emulsification pump body adopts a unique blade structure, mostly a single-blade or double-blade wheel structure, which effectively increases the probability of pollutants passing through, whether it is fiber, cloth strips, weeds or garbage, can pass smoothly. Experiments have shown that the fiber that can pass through the pump port of the emulsification pump is about five times larger than the pump port, and the maximum particle size is half of the pump port. In addition, the emulsification pump is a vertical structure and can work immersed in water, so exhaust is not a problem, and the maximum depth can reach seven meters.
This also greatly improves the safety factor of the emulsification pump. In addition, the overall structural design is relatively reasonable, so it can reduce noise, reduce space occupation, save energy and reduce emissions, facilitate operation and maintenance, and further ensure the quality and life of the pump body. And the size of the pump body connection is precise, which can ensure the stable and safe operation of the pump body without leakage and other hidden dangers. Therefore, whether it is for the transportation and pumping of clean water or the transportation of corrosive media, it can play a greater role, and it is convenient and safe, saving a lot of time and energy for operators.
This series of emulsification pumps adopts a unique impeller structure and a new mechanical seal, which can effectively transport solids and long fibers. Compared with the traditional impeller, the pump blade adopts a single-channel or double-channel form. It is similar to a curved pipe with the same cross-section size, has very good flowability, and is equipped with a reasonable volute chamber, which makes the pump have high efficiency. The impeller has been tested by dynamic balancing to make the pump vibration-free during operation.
Before using the emulsification pump, carefully check whether the pump and motor are damaged, and check the fastening of the fasteners; turn the pump to check whether there is any friction sound, and at the same time check the concentricity of the pump shaft and the motor shaft. The outer circle deviation of the two couplings should not exceed 0.5mm; the pipeline connected to the pump outlet should be equipped with a separate bracket, and its weight is not allowed to be added to the pump body; the water pump must be equipped with a fully automatic water pump control cabinet unless there are special circumstances. Do not directly connect to the power grid or use a knife switch to connect the current to ensure the normal operation of the water pump; the emulsification pump must not be operated in a low head state for a long time (the general use head must not be less than 60% of the rated head), and it should be controlled within the recommended use head range to prevent the water pump from burning the motor due to overload.
The mechanical seal of the emulsification pump adopts a new hard and corrosion-resistant tungsten carbide material, and the seal is improved to a double-end seal, so that it can operate in the oil chamber for a long time, which can make the pump run safely and continuously for more than 8,000 hours. The overall structure is compact, small in size, low in noise, and has significant energy-saving effects. It is easy to maintain and does not require a pump room. It can work by submerging in water, which greatly reduces the cost of the project. The emulsification pump can be equipped with a fully automatic safety protection control cabinet according to user needs, which can provide absolute protection against water leakage, leakage, overload and overtemperature of the pump, thereby improving the safety and reliability of the product. The float switch can automatically control the start and stop of the pump according to the required liquid changes, without the need for special personnel to supervise, and is extremely convenient to use.
